注册 | 登录 忘记密码? 51cto首页 | 博客 | 论坛 | 招聘
热点文章 伤离别,痛英年早逝,愿天..
 帮助

/31位掩码实验演示


2007-11-29 21:41:16
版权声明:原创作品,允许转载,转载时请务必以超链接形式标明文章 原始出处 、作者信息和本声明。否则将追究法律责任。http://allens21.blog.51cto.com/103334/52829
注意:/31位掩码只能用在点对点链路上
topo:  R1====R2=====R3
 
R1#sh run
hostname R1
interface Serial1/1
ip address 192.168.1.2 255.255.255.254
router rip
version 2
network 192.168.1.0
no auto-summary
==============================================
R2#show running-config
hostname R2
interface Serial1/0
ip address 192.168.1.3 255.255.255.254
serial restart-delay 0
!
interface Serial1/1
ip address 192.168.2.1 255.255.255.0
serial restart-delay 0

router rip
version 2
network 192.168.1.0
network 192.168.2.0
no auto-summary
===============================================
R3#sh running-config
hostname R3
interface Serial1/0
ip address 192.168.2.2 255.255.255.0
serial restart-delay 0
router rip
version 2
network 192.168.2.0
no auto-summary
================================================
实验验证:
R1#ping 192.168.1.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 48/77/124 ms
================================================
R3#ping 192.168.1.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 120/132/144 ms
================================================
R3#show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
   D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
   N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
   E1 - OSPF external type 1, E2 - OSPF external type 2
   i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
   ia - IS-IS inter area, * - candidate default, U - per-user static route
   o - ODR, P - periodic downloaded static route
Gateway of last resort is not set
    192.168.1.0/31 is subnetted, 1 subnets
R    192.168.1.2 [120/1] via 192.168.2.1, 00:00:05, Serial1/0
C 192.168.2.0/24 is directly connected, Serial1/0

本文出自 “MY Internetwork Tech” 博客,请务必保留此出处http://allens21.blog.51cto.com/103334/52829





    文章评论
 
2007-11-29 21:51:05
学习学习

2007-12-03 13:02:49
31 位掩码这么配置说明什么?

网络地址 ,广播地址 可用?

2007-12-16 20:35:40
31 位掩码用在p2p链路上节约ip地址,网络地址、广播地址可用

2008-03-29 22:52:32
31位掩码最好不要这么用在接口上面,有可能会产生一些莫名其妙的问题。但是在某些场合为了简化配置,比如说两台主机192.168.1.2和192.168.1.3是同样的关系,那么在做策略时候可以写在一起即192.168.1.2/31。

 

发表评论

昵   称:
验证码:  点击图片可刷新验证码  博客过2级,无需填写验证码
内   容: